ETS Lamborghini Gallardo and Audi R8 Billet Intake Manifold

ETS Lamborghini Gallardo and Audi R8 Billet Intake Manifold

When it comes to making power with your turbocharged Lamborghini Gallardo or Audi R8 the factory direct injection fuel system just isn't up to the task. By adding one of ETS Billet Intake Manifolds to the mix you can now run a secondary fuel system capable of supporting over 2000whp with the addition of 10 fuel injectors.

Stock like Drive-ability with maximum fuel delivery!

One of the key benefits to running a secondary fuel system is the ability to run the factory direct injection while cruising around town and then blend in the secondary fuel system as boost increases for maximum fuel delivery. This results in a vehicle that drives like stock while cruising around town and performs like a monster under wide open throttle.

** You will need to run a standalone engine management system like the Syvecs to blend in your secondary fuel system.

Designed to Perform!

Every manifold is assembled and pressure tested at 80 psi to ensure a leak free seal for maximum performance.

Application / Fitment

• 2008 - 2014 Lamborghini Gallardo 5.2L
• 2008 - 2015 Audi R8 V10 5.2L

Benefits

• Constructed of 6061 Billet Aluminum
• Direct bolt on design.
• Works with factory drive by wire throttle bodies.
• Integrated velocity stacks in the runner for optimal flow.
• Secondary Fuel Injection - The factory direct injection fuel system maxes out around 5.2 M/S, which is good for 900whp on MS109. Secondary injection allows for over 2000whp worth of fuel delivery.
• Designed to work with Bosch fuel injectors
• Available in Raw (Silver) or Anodized Finish (Black, Blue, Red, Gold and Purple)

What's included

• 20 Pieces Billet Intake Manifold
• Fuel Rails
• High Temp O-Rings and Gaskets
• Mounting Hardware
• Fuel injectors are sold separately and vary depending on your desired fuel type.

Availability

• Raw finish is in stock and ready to ship! Please allow 1.5 weeks for anodizing.

This piping kit is the best on the market for relocating the factory Subaru intercooler. The factory intercooler location allows for excessive heat soak and a poor amount of heat dissipation. This piping kit allows you to run a front mounted intercooler and get your cooler into cleaner and fresher air. This allows you to run a larger surfaced intercooler. Air is naturally forced through the front grill of your car, this is the logical location for your set up too run! This is piping only! No Intercooler included! This piping comes in a wrinkle black finish!

*NOTE* All piping kits now include an IAT bung and a plug.